Instructions for Use

MAGNIMOO – Magnetic Wall

Before Pasting

Not all walls are suitable. Do not apply on:

1. Damaged walls (not suitable)
2. Anti-fouling or waterproof walls, and diatom mud walls (may not be suitable)
3. Uneven surfaces (depends on the degree of unevenness)
4. High-temperature environments (above 60 °C)

Usage Steps

1. Take the board out of the tube. Expand it and place it flat on the ground with the blue protective membrane facing upward.
   
   
2. Use a book or similar weight to press the edges for at least 8 hours.
   
   
3. Ensure the board is fully stretched and no longer curling before you begin pasting.
   
   
4. Stick it all at once. Do not peel it off and re-stick, as this will reduce the adhesive strength.
   
   
5. Peel off a small section of the blue release film at the top and stick that part to the wall in the planned position. Press firmly with your palm so the adhesive fully contacts the wall and air bubbles are removed.
   
   
6. Gradually peel away the rest of the release film while pressing the board down evenly.
   
   
7. After application, press and smooth the board with your palm or a cloth from top to bottom and left to right to remove bubbles and improve adhesion.
   
   
8. Let the board sit for at least 5 hours before starting to use.

Important Notes

1. The adhesive is pressure-sensitive — press firmly to activate full bonding strength.
   
   
2. Adhesion may be weaker on large-particle or uneven walls, because the thin adhesive layer cannot fully contact the surface.
   
   
3. Best bonding is achieved on flat, smooth surfaces such as refrigerators, tiles, wooden boards, glass, iron doors, or painted walls.
   
   
4. Relocating too many times may reduce stickiness due to dust.

General Information

• The board is reusable and covered with a protective film — you can write on it with suitable markers and erase as needed.
  
• Do not expose to moisture — always apply on dry surfaces.